Mercury wet deposition in rural Korea: concentrations and fluxes

The characteristics of Hg wet deposition were investigated in a rural area of Korea from August 2006 to July 2008. The volume weighted mean (VWM) Hg(T) concentration and cumulative Hg(T) flux were 8.8 ng L(-1) and 9.4 μg m(-2) per year, respectively. The VWM Hg(T) concentration varied seasonally, similar to the seasonal pattern in atmospheric Hg(p) concentration. The enhancement of both VWM Hg(T) and atmospheric Hg(p) concentrations in spring and winter was likely caused by the long-range transport of Hg from China. Monthly VWM Hg(T) and atmospheric Hg(p) concentrations were well correlated (R(2) = 0.36); however, there was no correlation between VWM Hg(T) and RGM (reactive gaseous mercury) concentrations, suggesting that Hg(p) was responsible for the majority of the Hg in wet deposition at this site. The VWM Hg(T) concentration in snow was statistically higher than in rain. In addition, the atmospheric Hg(p) concentration appeared to be elevated for snow events as well. This suggests that both elevated Hg(p) concentrations and the enhanced scavenging efficiency of snow for Hg(p) were responsible for the elevated VWM Hg(T) concentrations measured during snow events.     

Degradation of different pesticides in water by microplasma: the roles of individual radicals and degradation pathways

Environmental Science and Pollution Research - Pesticides are emergent toxins often identified in aquatic environments. In the present study, microplasma was employed to reduce the pesticide...     

Settling and dewatering characteristics of granulated methane-oxidizing bacteria

We evaluated the settling ability and dewaterability of granulated methane-oxidizing bacteria (GMOB) after granulation using a continuous-flow reactor. A comparative analysis on settling and dewatering characteristics due to changes in sludge retention time (SRT, 10, 15 and 20 days) during cultivation of GMOB was conducted. In assessing dewaterability, the specific resistance to filtration (SRF) of activated sludge and GMOB was found to be 8.21×1013-2.38×1014 and 4.88 × 1012-1.98×1013 m/kg, respectively. It was confirmed that as SRT decreased, SRF of GMOB increased. In the case of bound extracellular polymeric substance (EPS), activated sludge registered 147.5 mg/g-VSS while GMOB exhibited 171-177.2 mg/g-VSS. In the case of extracellular polymeric substance soluble EPS in effluent, activated sludge measured 62 mg/L and GMOB had 17.4-21.4 mg/L. The particle size analysis showed that mean particle diameters of GMOB were 402, 369, and 350 μm, respectively, at SRTs of 20, 15 and 10 days. In addition, it was found that GMOB had a larger mean particle diameter and exhibited much better settleability and dewaterability than activated sludge did.     

Kinetics of the reduction of hexavalent chromium with the brown seaweed Ecklonia biomass

The dead biomass of the brown seaweed, Ecklonia sp., is capable of reducing toxic Cr(VI) into less toxic or nontoxic Cr(III). However, little is known about the mechanism of Cr(VI) reduction by the biomass. The objective of this work was to develop a kinetic model for Cr(VI) biosorption, for supporting our mechanism. The reduction rate of Cr(VI) increased with increasing total chromate concentration, [Cr(VI)], and equivalent concentration of organic compounds, [OCs], and decreasing solution pH. It was found that the reduction rate of Cr(VI) was proportional to [Cr(VI)] and [OCs], suggesting the simple kinetic equation -d[Cr(VI)]/dt=k[Cr(VI)][OCs]. When considering the consumption of organic compounds due to the oxidation by Cr(VI), an average rate coefficient of 9.33 (+/-0.65)microM(-1)h(-1) was determined, at pH 2. Although the function of the pH could not be expressed in a mechanistic manner, an empirical model able to describe the pH dependence was obtained. It is expected that the developed rate equation could likely be used for design and performance predictions of biosorption processes for treating chromate wastewaters.     

Comparisons of polybrominated diphenyl ethers levels in paired South Korean cord blood, maternal blood, and breast milk samples

Polybrominated diphenyl ethers (PBDEs), commonly used flame retardants, have been reported as potential endocrine disruptor and neurodevelopmental toxicants, thus giving rise to the public health concern. The goal of this study was to investigate the relationship between umbilical cord blood, maternal blood, and breast milk concentrations of PBDEs in South Korean. We assessed PBDE levels in paired samples of umbilical cord blood, maternal blood, and breast milk. The levels of seven PBDE congeners were measured in 21 paired samples collected from the Cheil Woman’s Hospital (Seoul, Korea) in 2008. We also measured thyroid hormones levels in maternal and cord blood to assess the association between PBDEs exposure and thyroid hormone levels. However, there was no correlation between serum thyroxin (T4) and total PBDEs concentrations. The total PBDEs concentrations in the umbilical cord blood, maternal blood, and breast milk were 10.7 ± 5.1 ng g⁻¹ lipid, 7.7 ± 4.2 ng g⁻¹ lipid, and 3.0 ± 1.8 ng g⁻¹ lipid, respectively. The ranges of total PBDE concentrations observed were 2.28-30.94 ng g⁻¹ lipid in umbilical cord blood, 1.8-17.66 ng g⁻¹ lipid in maternal blood, and 1.08-8.66 ng g⁻¹ lipid in breast milk. BDE-47 (45-73% of total PBDEs) was observed to be present dominantly in all samples, followed by BDE-153. A strong correlation was found for major BDE-congeners between breast milk and cord blood or maternal blood and cord blood samples. The measurement of PBDEs concentrations in maternal blood or breast milk may help to determine the concentration of PBDEs in infant.     

Laboratory determination of compost physical parameters for modeling of airflow characteristics

Physical parameters of 12 co-compost cover materials were experimentally determined and predicted variations in airflow characteristics were evaluated under varying moisture contents. Predicted air-filled porosity showed high correlation with measured air-filled porosity, facilitating development of a reliable model of air-filled porosity that makes it possible to predict the effect of varying moisture content and compost bed height on air-filled porosity and permeability. Predicted air-filled porosity decreased with increasing moisture content and compost depth for all materials. Air-filled porosity of corn stalks, oat straw, soybean straw, leaves, alfalfa hay, wheat straw, silage, wood shavings and sawdust was in the range of 38-99%. Turkey litter, soil compost blend and beef manure showed air-filled porosity values less than 30% near saturation and the bottom of pile. In concert with the findings of other researchers, effective particle size of all materials increased with increasing moisture content from 20% to 80% of water holding capacity (WHC). It increased dramatically near saturation. In general, permeability increased with increasing air-filled porosity and decreasing bulk density, but the relationship between permeability and moisture content is complex. Permeability is dependent on the balance between particle size and air-filled porosity. If the influence of aggregated particle size on the permeability is significant, it will compensate for the effect of reduced air-filled porosity caused by compaction and moisture content. In this case, permeability will increase; in the reverse case, it will decrease. Permeability decreased for corn stalks, oat straw, silage, wood shavings, soybean straw, sawdust, turkey litter and wheat straw with increasing moisture content from 20% WHC to 50% WHC, regardless of the depth of the compost bed. But the permeability increased with increasing moisture level from 50% to 80% WHC at moderate to shallow simulated bed depths. The soil compost blend and leaves showed the permeability increasing when the moisture increased not only from 50% to 80% WHC but also from 20% to 50% WHC. Permeability of alfalfa hay and beef manure always decreased with increasing moisture levels and pile depth. In this study the maximum wet bulk density and mechanical strength decreased with increasing the moisture content. The method described for determining physical properties under varying moisture contents and compost bed depths will be very useful for designing and modeling airflow characteristics of a mortality composting process with a variety of materials.     

Two-generation toxicity study on the copepod model species Tigriopus japonicus

Previous studies on the intertidal copepod Tigriopus japonicus have demonstrated that it is a suitable model species for the assessment of acute toxicities of marine pollutants. In order to standardize T. japonicus for use in environmental risk assessment involving whole life cycle exposure, we tested nine pollutants for their effects on growth and reproduction during a two-generation life cycle exposure test. Nauplii (F 0) were exposed to a range of concentrations of each chemical in a static renewal culture system. Broods of the second generation (F1) were subsequently exposed to the same concentrations for one full life cycle. Of the seven traits (nauplius phase, development time, survival, sex ratio, number of clutch, nauplii per clutch and fecundity), only the length of the nauplius phase and development time showed a greater sensitivity to chemical exposure. Between the two sensitive traits, the period of the nauplius phase was more sensitive than cohort generation time. Biocides significantly increased the maturation period of nauplii as well as copepodids in F 0 generation. In this study, it was demonstrated that T. japonicus could also be used in reproduction and life cycle tests and it provides an opportunity for testing the chronic and subchronic toxic effects of marine pollutants. Further validation and harmonization in a multi-centric study involving other laboratories of the region will strengthen its use as a supplement to existing model species.     

Development and Application of Green Composites: Using Coffee Ground and Bamboo Flour

Environmental degradation and global warming are increasing as a result of the use of petroleum. Therefore, many industries are seeking more eco-friendly materials that will decrease the level of environmental contamination and economic cost. Recently, the level of coffee consumption has increased rapidly. Therefore, the amount of coffee grounds discarded is increasing. In this study, polylactic acid, coffee grounds and bamboo flour were compounded for green composites. Coffee grounds are used in the recycling of food waste. In addition, 4,4-methylene diphenyl diisocyanate (MDI) was used as a coupling agent. The mechanical strength of green composites decreased with increasing natural filler content. However, mechanical and thermal properties were increased by the addition of MDI as a coupling agent. The hydroxyl groups of natural fillers reacted with the isocyanate group of MDI, and a urethane linkage was created between the polymer and natural fillers.     

Factors influencing concentrations of dissolved gaseous mercury (DGM) and total mercury (TM) in an artificial reservoir

The effects of various factors including turbidity, pH, DOC, temperature, and solar radiation on the concentrations of total mercury (TM) and dissolved gaseous mercury (DGM) were investigated in an artificial reservoir in Korea. Episodic total mercury accumulation events occurred during the rainy season as turbidity increased, indicating that the TM concentration was not controlled by direct atmospheric deposition. The DGM concentration in surface water ranged from 3.6 to 160 pg/L, having a maximum in summer and minimum in winter. While in most previous studies DGM was controlled primarily by a photo-reduction process, DGM concentrations tracked the amount of solar radiation only in winter when the water temperature was fairly low in this study. During the other seasons microbial transformation seemed to play an important role in reducing Hg(II) to Hg(0). DGM increased as dissolved organic carbon (DOC) concentration increased (p-value < 0.01) while it increased with a decrease of pH (p-value < 0.01).     

Distribution of inorganic arsenic species in mine tailings of abandoned mines from Korea

The main objective of the present study is to determine arsenic species in mine tailings by applying an ion exchange method. Three abandoned mines, Jingok, Cheonbo and Sino mines in Korea, which had produced mainly gold, were selected for the collection and analysis of the tailings. It was found that the arsenic speciation using an ion exchange method was effective to separate As(III) and As(V) in leachate of mine tailings. The concentration of As(V) was found to be 63-99% in the leachate, indicating that As(V) would be the major arsenic species in the mine tailings and the tailings were under oxic conditions. The total concentrations of arsenic and metal elements in the mine tailings were up to 62,350 mg/kg As, 40 wt.% Fe, 21,400 mg/kg Mn, and 7,850 mg/kg Al. Sulfate was the dominant anion throughout the leachate, reaching a maximum dissolved concentration of 734 mg/l. The results of XRD and SEM in the mine tailings showed that main arsenic-containing minerals were pyrite (FeS2) and arsenopyrite (FeAsS) which would be the source of arsenic contamination in the study area.